CCNA考题分析

文章作者 100test 发表时间 2011:03:17 20:21:40
来源 100Test.Com百考试题网

问题：

you are a cisco certified expert.you have been contracted by the testcenter pro chain to fix a problem that was caused by a mcp certified technicician who could net complete the configuration of the routers.

this testcenter pro chain has three stores and wanted to maintain their bicycle repair business in a centralized manner through network connectivity.they then asked the local mcp certitified technician to configure the routers,but the technician failed to establish connectivity among the routers.

the routers are named router1,router2,and router3,respectively.

identify the fault and make the appropriate change(s) to rectify the configuration fo the routers.the mcp technician configured the routers with the specification that follows:

·the routers are named router1,router2,router3
·rip is the routing protocol
·clocking is provided on the serial 0 interfaces
·the password on each router is pconline
·the subnet mask on all interfaces is the default mask.
·the ip addresses are listed in chart below.

router1：

e0 192.168.27.1
e1 192.168.29.1
s0 192.168.31.1
secret password:pcjob

router2：

e0 192.168.35.1
s0 192.168.33.1
s1 192.168.31.2
secret password:pcjob

router3：

e0 192.168.37.1
s1 192.168.33.2
secret password:pcjob

to configure the router you need to click on the host icon that is connected to the router by a serial cable.

有一名mcp配置的路由器无法连通，请你去帮忙给解决，情况如下：

·路由器被命名为router1，router2，router3
·使用rip协议
·serial 0时钟设置
·每个路由器的密码都是“pcjob”
·所有接口的子网掩码均为默认掩码

解答：

命令后面的注释只在第一次出现时进行提示讲解。

路由器1在主机2上配置：

router1