CCIE最新模拟考试题_思科认证考试

文章作者 100test 发表时间 2007:03:14 13:11:10
来源 100Test.Com百考试题网


1.What statement is FALSE with respect to the operation of Unidirectional Link Detection?   
A. It negotiates the Unidirectional Link Detection link state during physical signaling.   
B. It performs tasks that autonegotiation cannot perform.   
C. It works by exchanging protocol packets between the neighboring devices.   
D. Both devices on the link must support Unidirectional Link Detection and have it enabled on respective ports.   

2.What is true concerning Traffic contract, Traffic shaping, and Traffic policing in ATM networks?   
A. They are parameters of PNNI set during PNNI configuration.   
B. They are forms of QoS features used in ATM networks.   
C. They are types of SVCs.   
D. They are types of PVCs.   
E. They are only used between ATM switches to control traffic flows.   

3.Which are the primary reasons to use traffic shaping? (Select two)   
A. To control the maximum rate of traffic transmitted or received on an interface.   
B. To control access to available bandwidth.   
C. To define Layer 3 aggregate or granular incoming or outgoing bandwidth rate limits.   
D. To control the average queue size by indicating to the end hosts when they should temporarily slow down transmission of packets.   
E. To ensure that traffic conforms to the policies established for it.   

4.In a bridged network running IEEE 802.1d spanning tree, what parameter will a bridge take form the root bridge?   
A. Maxage   
B. Forwarding delay   
C. Hello time   
D. All of the above   

5.What statement is FALSE concerning the use of SPAN on the Catalyst 6500?   
A. It is possible to configure SPAN to have a Gigabit port, such as source port, and a 10/100 port as the destination port.   
B. If the source port is configured as a trunk port, the traffic on the destination port will be tagged as well, regardless of the configuration on the destination port.
C. When a SPAN session is active the destination port does not participate in Spanning Tree.   
D. With SPAN an entire VLAN can be configured to be the source.   
E. In one SPAN session it is possible to monitor multiple ports that do not belong to the same VLAN.

相关文章


ccna最新真题:TCP_IPAddressingandProtocol
ccna最新真题:BasicIOSConfiguration
CISCO资格认证考试:CCNP模拟试题-BSCI
CISCO资格认证考试:CCNP模拟试题-BCMSN
CCIE最新模拟考试题_思科认证考试
CISCO资格认证考试:CCNA模拟试题
CISCO模拟试题:CCNA考试自测题1
CISCO模拟试题:CCNA考试自测题2
思科认证考试(CCNA)考试模拟题01—19及答案
澳大利亚华人论坛
考好网
日本华人论坛
华人移民留学论坛
英国华人论坛